STATUS: FINAL DESIGN
Printable modular case with room for an RGB(W) strip.
It uses Adafruit Nanopixels 144/m but any other strip will work too.
It uses an Arduino to control the strip and pinchinettes input circuit to cap the input voltage to 5V. As it doesn’t need an attenuator I skipped the top left part of the circuit and ended up with the following circuit:
The print itself is nothing special. One part is 5cm wide and provides a 2cm hole to fit cables from top to bottom and a 3mm hole to screw it together.
The easiest way to print it is to define how wide you want it, print full width parts and use the width of the last part to get the hp you want.
FOLDED BINARIES 
Leave a comment